RAMMS

  • Increase font size
  • Default font size
  • Decrease font size
Error
  • Copy failed
Welcome, Guest
Username: Password: Remember me
All about the visualization and interpretation of RAMMS model results
  • Page:
  • 1

TOPIC: time plot problem

time plot problem 5 years 2 months ago #76

Hallo
I want to ask you about my problem with time plot creation....
I went forward according to RAMMS avalanche manual, but no time plot was created. After I clicked on the point of interest, just the information about the value in this point was displayed


When I open the output project, this error message is displayed


Is this the probleme, why I can not create a time plot?
Thanks for you answer
Greetings
Last Edit: 5 years 2 months ago by JozefRichnavsky.
The administrator has disabled public write access.

time plot problem 5 years 2 months ago #77

  • Yves
  • Yves's Avatar
  • OFFLINE
  • Administrator
  • Posts: 18
Dear Jozef

You have displayed the maximum values. There are no time plots for these values because they don't change over time. Please change to the time steps, then time plots can be displayed.

Greetings from Davos
Yves
Dr. Yves Bühler
WSL Institute for Snow and Avalanche Research SLF
Avalanches, debris flows and rockfall research unit
Flüelastrasse 11 CH-7260 Davos Dorf
Tel: +41 81 4170 163
Fax: +41 81 4170 110
E.mail: This e-mail address is being protected from spambots. You need JavaScript enabled to view it
The administrator has disabled public write access.

time plot problem 5 years 2 months ago #78

Thank you for your prompt answer and solution.
Of course you are right, I have tried to make time plot from MAX values, what is nonsense :) (I have not noticed it)
In the result of flow height everything works fine....
Greetings

Jozo
The administrator has disabled public write access.
  • Page:
  • 1
Time to create page: 0.032 seconds

Affiliation

Banner
Banner

© SLF/WSL 2010